GeneralKimbo Posted March 19, 2016 Posted March 19, 2016 Hi I recently bought G&Gs CM16 MOD 0 as my starter weapon and I like it very much. But I have no idea how to remove the stock and all guides I've found have been about the raider or the carbine. Any help much appreciated.
Guest PT247 Posted March 19, 2016 Posted March 19, 2016 the pin in the hinge just needs lowering further, stick a screwdriver between it and the lever to lift it further
GeneralKimbo Posted March 19, 2016 Author Posted March 19, 2016 That sounds like I good idea I just don't really understand what you mean.
Supporters Sitting Duck Posted March 19, 2016 Supporters Posted March 19, 2016 or if ya tough guy use ya fingers to remove the v2 stock are you just gonna put a bit of tape on it to reduce stock wobble or you wishing to rip her open - don't is best advice and it is front wired - I'm sure you know that already
Supporters Sitting Duck Posted March 19, 2016 Supporters Posted March 19, 2016 you need to look at stock closely..... the locking lever activates a pin going through that pulls down retracting the lug to adjust positions you need to pull that pin down further... slide stock to rear of gun - then once at back you need to pull that pin down a bit further and she will slide off fingers if ya tough enough or use something like flat screwdriver etc to lever pin down further so the lug completely clears the rear of stock tube jeeez
Guest PT247 Posted March 19, 2016 Posted March 19, 2016 That sounds like I good idea I just don't really understand what you mean. there is a hinge that you use to adjust the pull of the stock, it has a pin. The pin only moves a certain amount with the lever, force the pin to move further by utilising a flat head screwdriver to lift it further.
GeneralKimbo Posted March 19, 2016 Author Posted March 19, 2016 Oh I see awesome ? I used my fingers (are you proud hehe)
GeneralKimbo Posted March 19, 2016 Author Posted March 19, 2016 Aw I was happy until the stock I wanted to put on didn't fit. Ah well refund time. (For stock not gun lel)
Supporters Sitting Duck Posted March 19, 2016 Supporters Posted March 19, 2016 Oh I see awesome I used my fingers (are you proud hehe) Aw I was happy until the stock I wanted to put on didn't fit. Ah well refund time. (For stock not gun lel) Yes - you are a beast..... what stock no fit then ??? what was up with old one - its a good stock and front wired means you not gotta mess about removing it to change batteries like on FireHawk
GeneralKimbo Posted March 20, 2016 Author Posted March 20, 2016 Yeah it's a nice stock was just going to use one with a housing in the back to store spare batteries lol ?. I'm not sure what stock it is lel a friend have it me.
Supporters Sitting Duck Posted March 20, 2016 Supporters Posted March 20, 2016 Well - change battery at lunch time if battery dies before lunch it is f*cked or a low capacity one and you spraying and praying too much most of us use 1 lipo in morning, change battery lunchtime - job done if you think about it, say you put on a crane stock... you still gotta take out the old battery, open crane stock, swap them over, replace old battery in crane and close it all back up again on the field etc...... your battery should last until lunch - if not it is probably a dying nimah 8.4v or something so in that case you don't need new stock but new batteries - lipo perhaps one day
Recommended Posts