cassette Posted September 14, 2021 Posted September 14, 2021 i field stripped my vorsk pistol and now when i try to put it back together the slide doesn’t go far enough back to put it back together, can someone help?
BigStew Posted September 15, 2021 Posted September 15, 2021 It should be straight forward. Is the barrel able to move freely in the slide when it's off the frame barrel a guide rod would be the most likely culprit. Next make sure the barrel is seated properly before trying to fit it. Also can't see from the pics is the hammer cocked when you try to fit the slide?
Cr0-Magnon Posted September 15, 2021 Posted September 15, 2021 Are the sear bits at the back pushed down?
AirSniper Posted October 5, 2021 Posted October 5, 2021 Sorry.... All I can say is if the barrel is not properly located or the returning spring located in the receiving hole is not fully seated then you may encounter the issue I encountered when I nearly jammed the slide on my sons Glock and it got stuck, the reason was that the barrel was not properly seated and said spring was not located in its receiving hole and slider locked up. Have you not seen any Youtube Videos on this pistol where the owner strips the pistol down?
EDcase Posted October 8, 2021 Posted October 8, 2021 I just got one and noticed that it takes some wiggling to get the slide back on because the spring guide gets stuck on the frame in the lower. (Not very well designed) PM me if you need more info.
Rikki Morgan Posted October 31, 2022 Posted October 31, 2022 Wiggle the outer barrel as u gently slide it on thats all it needs
Recommended Posts