Skippy77 Posted October 19, 2022 Posted October 19, 2022 I've already upgraded my Striker AS01 with an ESD Piston upgrade set but fitted a M140 spring instead of the M150. I chrono'd this and it was shooting 498-500fps. So lucky I didn't fit the M150 spring using .20. The kit came with a Steel Sears and I fitted this. My issue is the BB's aren't shooting properly, they're dropping and shooting multiple bb's so it's not feeding properly. I'm going to fit a Action Army Hop Unit in this, however I've read that the Hop Up Rubber fitted isn't very good on these bb guns. What one do I need? I'm not sure what Hop Up Rubber to use. I've seen there's loads and different angles. 50, 60 & 70 degrees. Will these fit in ok? https://www.bztactical.co.uk/asg-madbull-shark-blue-hop-up-rubber-8032 I'm buying this and want something to fit this; https://www.bztactical.co.uk/action-army-amoeba-striker-hop-up-chamber I've seen there's a CNC Feed Ramp but can't seem to find any where in the UK that sell this. Does anyone know where I can get one? Thanks.
Recommended Posts