Cr0-Magnon Posted March 24, 2023 Posted March 24, 2023 I'm not actually using a Maxx hop unit but this is the only pic I could find with a notch where the barrel clip goes. Anyway, when fitting a hop rubber I can still see it through this notch, does it need to be trimmed a little bit until I can't see it at all?
alxndrhll Posted March 24, 2023 Posted March 24, 2023 58 minutes ago, Cr0-Magnon said: I'm not actually using a Maxx hop unit but this is the only pic I could find with a notch where the barrel clip goes. Anyway, when fitting a hop rubber I can still see it through this notch, does it need to be trimmed a little bit until I can't see it at all? Certainly not an expert but whenever this has been the case for me I’ve trimmed it if the C clip won’t engage properly, leaving the hop unit not secured into place with the barrel. If the C clip still fully clips in there isn’t really any reason to though. Cr0-Magnon 1
Supporters Adolf Hamster Posted March 24, 2023 Supporters Posted March 24, 2023 If the clip fits don't worry about it. You might want to check the rubber isn't getting stretched when pushing the barrel into the hop unit. Made the mistake of buying a madbull hop unit which was so damn tight it would pull the hop unit over the end of the barrel when fitting.
Cr0-Magnon Posted March 24, 2023 Author Posted March 24, 2023 I shortened it a smidge, so it sits literally flush to the back of the clip. Think that'll do. Now all I need to figure out is how to keep the motor connectors on this ERG ?....the positive keeps popping off.
Davegolf Posted March 25, 2023 Posted March 25, 2023 Can’t you just pinch the connector a little tighter?
Recommended Posts