johnnyj Posted June 7, 2023 Posted June 7, 2023 Hi everyone. I got my hands on a cheap m3 scope and noticed the rear of the scope is wonky lol . Scope works fine etc but just knowing it's like that is setting ocd off. Are the back of these pressure fitted or screwed? Thanks for any insights
Supporters Lozart Posted June 8, 2023 Supporters Posted June 8, 2023 21 hours ago, johnnyj said: Hi everyone. I got my hands on a cheap m3 scope and noticed the rear of the scope is wonky lol . Scope works fine etc but just knowing it's like that is setting ocd off. Are the back of these pressure fitted or screwed? Thanks for any insights Cheap new or cheap second hand?
johnnyj Posted June 8, 2023 Author Posted June 8, 2023 34 minutes ago, Lozart said: Cheap new or cheap second hand? Cheap second hand . Cleans up nice so far
Supporters Lozart Posted June 8, 2023 Supporters Posted June 8, 2023 1 minute ago, johnnyj said: Cheap second hand . Cleans up nice so far In that case it may have been dropped/fallen on so the lenses might not line up properly if the tube itself is bent. If it's a purged scope and you strip it then you'll lose any seal and potentially start getting condensation inside the sight. If you can adjust it to hit what you're pointing it at then just leave it be.
Hudson Posted June 8, 2023 Posted June 8, 2023 How do you mean, 'wonky'? What exactly is wrong with it?
JimFromHorsham Posted June 8, 2023 Posted June 8, 2023 (edited) If you mean the IR Turret , it’s ment to be offset , so you can read the elevation turret ?? If the eye bell is bent / not in line then that’s likely just China QC . Edited June 8, 2023 by JimFromHorsham Extra Hudson 1
johnnyj Posted June 8, 2023 Author Posted June 8, 2023 All good advice guys. Jim and Hudson, its the very back of the scope ( Bell) . From what I can gather it's an old scope that was mounted to a m14 and the angle is fitting for an impact/ fall . Thanks for all the input, I will just live with it Lozart 1
Supporters Lozart Posted June 12, 2023 Supporters Posted June 12, 2023 On 08/06/2023 at 20:42, Hudson said: How do you mean, 'wonky'? What exactly is wrong with it? If you look at the first picture you can see that the end bell is drooping slightly. On 08/06/2023 at 21:08, johnnyj said: From what I can gather it's an old scope that was mounted to a m14 and the angle is fitting for an impact/ fall . Which is EXACTLY how I bent mine! johnnyj 1
Dan Robinson Posted June 12, 2023 Posted June 12, 2023 7 minutes ago, Lozart said: you can see that the end bell is drooping slightly. It comes with age apparently. Unlike maturity Shamal, johnnyj and Lozart 3
Recommended Posts