BlackFox888 Posted July 8 Posted July 8 Hello everyone. I recently bought a T238 Active Break mosfet, I did quite a bit of modding before, but this is my first time wiring a mosfet. I hooked up everything according to the schematics, but when the trigger is pulled, the motor doesn't spin at all. Did I wire up something improperly? What could be the issue? Excuse my bad soldering, I also didn't use shrink tubes for now, in case I mess something up. Images and the wiring scheme is attached below. Thanks for any help.
Supporters Lozart Posted July 8 Supporters Posted July 8 I think the issue may be your soldering. The red wire through the centre(ish) of the board looks like a very dry joint, as do the connections on the battery connector.
Recommended Posts