Leaderboard

I have always fancied one of these for a bit of fun. Let men know when you are bored of it I might take it off your hands if I haven’t scratched my SMG itch by then. (I’ll expect a message sometime next week ?).....

Oh yes have to agree one I had to have in my collection too! Looks just like the Alpha tech grenade, had one but lost it, tried to get another one but apparently they got sued, I am all over this one though looks great!!

Wanted one for ages...sold a load of unused bits to fund it, but, well...

As I can't play airsoft right now, I might as well write about it... This time I share my thoughts on load bearing gear in airsoft, as I see people asking if they should use a chest rig or plate carrier all the time. I think load bearing equipment is very important, both from a practicality perspective and an aesthetic one. After all, airsoft is also very much about the dress up! https://www.impulse101.co.uk/post/plate-carrier-vs-chest-rig-my-thoughts-on-load-bearing-gear

TM Walther MPK.

Once in a while I am allowed to touch the jar. Only when I have been good though.

Excited to let you all meet the new Specna Arms Edge 2.0 H-Series!

So on inspection there was not only the sharp edges of the trigger guard wings but also a hefty burr from a knock it had taken. I cleaned up the burr with some fine wet&dry paper, de-greased the area and then masked it off ready. I used black Sugru to fill the gap and blend into the trigger guard wings and also around the scuffed area. I let it set over night and removed the tape then used a craft knife to tidy up the front where it had overlapped the tape. Feels great and you would not notice it unless you turned the gun over and squinted ?

Oh dear what have I done. But still one of the prettiest guns I have laid eyes upon (Ares DSR1)

Haven't tried it yet but got the quake 8. Would of liked a trmr but we know that won't happen. Looking forward to using it

My new Tectonic Quake BFG and cylinder for Well MB12